This is commonly use nowadays because it have good security. I recommended to use WPA2 only Security Mode and TKA+AES encryption.
#Configure mac address for access internet dlink password
Then choose Security Setting to set up a new password for you Wi-Fi SSID.
To solve this, once again click on ADVANCED tab and choose Advanced Wireless.
Now, you Wi-Fi connection is not secure which mean it’s open to public, everyone can join the network without authorization. Pick your SSID as in my case I put it as FTE dlink and click Apply to save. My recommendation is the leave the top setting at default and what you need to change in this page is only the SSID. To do it click on ADVANCED tab and choose Advanced Wireless like the picture below. With this feature configure, any devices that has Wi-Fi capabilities can enjoy the Internet too. If everything is correct, you should now have Internet access.Īfter we have Internet access, now we want to set up the wireless LAN or Wi-Fi. Please consult your ISP provider customer service regarding the PPP username and password. Just leave the others at default settings. What we need to change here is to choose correct VPI/VCI value, encapsulation mode, and most importantly your PPP username and password. On Protocol we are using PPPoE (PPP over Ethernet) and LLC encapsulation mode.Ĭlick on SETUP tab choose on Internet Setup. The VPI/VCI settings are different according to your ISPs in different countries, so make sure you get it right. As for Malaysia, it uses VPI 0 and VCI 35. You can check which value is used in your country. In this session what you need is the PPP username and password that you can retrieve from ISP customer service, VPI and VCI value according to the country. If you have any problems, you might have to call customer service for assistance. Make sure you have all the configuration details from your ISP. Setup Username and IDįirst of all before we are able to use the Internet connection, we must setup the username and ID in the ADSL modem. Make sure it’s connected to a PC with an Ethernet cable.
Before we get started, make sure to power-on the modem and connect all the necessary cables.
0 kommentar(er)
